Receiver Menu. AttitudeControl Self leveling. Bank Switching. Factory reset. Version information. Firmware update. During this time do not move the sticks on your radio as the system is learning the stick mid positions. During this time do not move the helicopter. When initialization is completed the Status LED will change to blue or purple color indicating the current gyro mode. Note that during initialization pressing the button has no significant effect and you will not be able to enter any menu.
Now when the system is ready to operate press the button and hold it for at least 3 seconds. Now and only now you can release the button. Proceed step by step through the different menu points reaching from A to N and perform the basic adjustment as described in the following. By briefly pushing the button at each step you will save the current setting and proceed to the next step. If you need to change some specific setting later onwards you can enter the SETUP MENU again as described above and skip menu points by only pressing the button without changing anything at these points.
So you can navigate to the desired menu point by simply pressing the button several times until you reach this point. Then after you have finished the adjustment, again press the button repeatedly to proceed to the end of the menu and to get back into operation mode. After doing so you will not be able to fly anymore! There are 2 exceptions: When you press down and hold the button at Menu Point H Servo trims only the servo trims will be reset to 0.
Holding the button will not cause a full factory reset here. In this condition the gyro control and the stick controls are disabled. Most often the rudder stick is used to change or adjust a value, i. And on the other hand the aileron stick roll is used to switch between menu items, i. There can be exceptions, so sometimes the sticks simply do what they are supposed to do i.
If not it will be mentioned in the instructions. See general informations about StudioXm if you need further instructions. The options you see here are basically similar to the SETUP MENU points A to M you can change directly at the device, but there might be little differences because of the different nature of the interactive setup.
Factory reset. Version information. Firmware update. It can be used with many different types of helicopters like 3D aerobatic helis, F3C competition helicopters as well as scale helicopters with 2 or more rotorblades.
The system comes with basic flybarless stabilization functionality and can be upgraded by paid update to the "ProEdition". This enables additional features like AttitudeControl for recue bailout or constant leveling and a feature called Bank Switching which allows to change between different parameter presets in flight to serve different flight conditions or flying styles. All you need is your radio system and your helicopter. Thanks to the well proven EasySetup system you can do all the necessary adjustment directly at the device and in very short time.
This online manual is very extensive and covers all topics in detail, i. So reading this manual can give you a detailed knowledge about the system and should help to give answers to almost all questions you may have.
Anyhow, for a first start you may just go with the quick start guide and only refer to the online manual if you have some specific question. Also the quick reference card can give you a good overview for the different menu structures and adjustment procedures that can be performed directly at the device. During initialization also you can directly read from the display of the device what firmware version it is running: After power up when the Status-LED lights red, for a few seconds the Menu-LEDs A to G display the first digit of the firmware version and the LEDs H to N the second digit.
In the right row LED I lights up which stands for minor version "2". Jump to: navigation , search. Introduction 2. Safety notes 3. Box content and accessories 4. Hardware installation 5.
0コメント